Fiberglass chopped strands.
10 lbs $28.00
For Epoxy or Polyester resins
1/4 inch in length
In simple laymen’s terms, adding chopped strands to epoxy or polyester resin is like adding re-bar to concrete.
The chopped strands act to make the resin stronger.
Chopped strands increase mechanical strength, and increase the tensile strength impact resistance, and compressive and flexural strength.
They improve dimensional stability, and minimize distortion at elevated temperatures.
Chopped strands can be used to increase the ability of resins to bridge gaps.
They should be added where increased strength is needed fro bonding, filleting, and fastening with resin.
- mix your resin and hardener, or catalyst
- next add your chopped strands
- it is best to use a paint mixer on your power drill to ensure that all of the strands are properly saturated.
Thick layers and large pour areas can create excessive heat, so proceed with caution.
Read before using:
Dry powder materials can build up static charges. Proper precautions must be taken in the presence of flammable liquids.
Can cause eye irritation, harmful if inhaled, may cause skin irritation. Harmful if swallowed.
Avoid contact with eyes, and contact with skin. Wear goggles and face shield when handling. Always wear an approved respirator. Use only with adequate ventilation. Keep away from heat , spark and flame. Store handle and use in a manner that minimizes dust generation.
In case of contact with skin, wash with warm water and soap. For eyes immediately flush with water for 15 minutes. If irritation continues seek medical attention. If inhaled, move to a fresh air environment .. If you have breathing difficulties seek immediate medical attention
Attention: container may be hazardous when empty. Empty containers contain product residue.
If you would like the MSDS sheet, e-mail your request to
KEEP OUT OF REACH OF CHILDREN !!!
FiberglassSite@comcast.net , and it will be sent you in a PDF file , or in any manner that you request.